600D: Flash Setting. Jan 9, 2012. Forgive me for not knowing off the top of my head correct terminology - my camera is not in front of me. My camera has a setting that allows, during flash photography in AV mode, for the shutter to stay open for a longer duration to expose a dark background. Err 01. The communication between the camera and lens is faulty. Very gently clean the electrical contacts (highlighted in red) on the camera and the lens using a clean and dry cloth. Do not wipe the contacts with a wet cloth. Do not touch the contacts directly with your hands. Touching them with your hands could cause corrosion, which would Solution. The quickest way to check if this is the issue causing your Canon camera to show a ‘busy’ signal is to turn the flash off. If you turn flash off and your Canon Rebel camera no longer shows the ‘busy’ message then the recycling time is likely to be the issue at hand. There are things that affect the recycling time. well, one thing I could suggest - get an other lens, 18-55 is bad, real bad. in budget range there are either 17-85 f/4-5.6 IS USM by canon, it is not awesome but much, much better, or tamron 17-50 f/2.8 (get one without stabilizer, much better picture) anything else would cost more than your camera. However, the 600D has no in-camera level and its smaller battery is the same as the one used in the 550D. For the enthusiast photographer on a budget the Canon EOS 600D is extremely well specified, with the highlights being the 18-million-pixel sensor and the high-resolution articulated rear screen. Features in use: Black & white filters Canon 600d + Intervalometer issues - posted in Beginning Deep Sky Imaging: Hi all, seen this on another forum but didnt solve So last night, new modded Canon 600d camera and used the same intervalometer as my other camera Did a 1 minute Delay 2 Minute exposures 5 seconds between each exposure 30 images pressed go and left When I came back the Exposure setting was stuck on basically the hour!! 2. Set the Mode Dial to < >. 3. Press the < > button to set to the Quick Control state. 4. Press the < > keys to select [backgnd: Blurred <-> Sharp]. If you move the index mark toward the left, the background will look more blurred. If you move it toward the right, the background will look more in focus. pfC5q.

canon 600d camera settings